Wireless XLR Mic Transmitter and Receiver, 5.8GHz

Cut the cable on your dynamic mic in seconds - clean signal, tight timing.

This 5.8GHz wireless system converts dynamic or moving-coil XLR microphones into a wireless setup. It includes one XLR female transmitter and one XLR male receiver: plug the transmitter into your mic or mixer output, then run the receiver into a mixer, PA, audio interface, or XLR-equipped camera. Working in the 5.8GHz band, it resists common 2.4GHz and UHF interference for a stable link over typical stage and location distances.

Why we picked it

• Fast conversion - The plug-on transmitter and receiver make wired dynamic mics wireless in seconds.
• Clean digital audio - A 24-bit/48kHz path with 20Hz-20kHz response, 105dB signal-to-noise, distortion below 0.02%, and latency under 5ms.
• Flexible setups - Rechargeable batteries, simultaneous charging, and multi-channel support.

Good to know

Batteries run about 3.5-5 hours per charge, and the included cable charges both units at once. Up to four sets can run on separate channels in one space. It's built for dynamic and moving-coil mics with XLR connectors, not condensers that need phantom power from the transmitter. In open areas the link can reach around 100 feet; walls and metal reduce that.

Common questions

Q: Which mics work?
A: Dynamic and moving-coil mics with XLR connectors, not condensers needing phantom power from the transmitter.

Q: Can I run several systems together?
A: Yes, up to four sets on separate channels in one location when correctly paired.

Q: What's the range?
A: Up to about 100 feet in open spaces; walls, metal, and RF sources reduce it.

Q: How do I pair the units?
A: Power both on, connect them, then long-press the channel button; a solid blue indicator means the link is set.